L'article a été ajouté avec succès.
67 plus d´articles de cette catégorieAfficher plus d´articles

Rohloff Splined Carrier Adapter with Snap Ring Circlip small

Rohloff-Splined-1.jpg
Rohloff-Splined-2.jpg
   
Cet article n'est pas disponible actuellement !
Veuillez m'informer dès que l'article est à nouveau disponible.
  • pas disponible
PPC* 27,90 € € 23,95
économisé 14 %

incluse 19% TVA, plus 3,99 € de frais d'expédition

Demande de meilleur prix

Si vous trouvez un article a  un prix inférieur chez un autre détaillant Internet commercial, vous le recevrez de notre part au même prix, a  condition que les conditions énumérées dans le lien soient remplies.

Pour plus de détails sur la Garantie du meilleur prix, cliquez ici :
Garantie du meilleur prix sur les vélos a  prix réduit

La meilleure demande de prix ne sera traitée qu'après que votre commande ait été soumise.
L'octroi d'un meilleur prix est non cumulable avec d'autres promotions (par exemple "articles gratuits) de Bike-Discount.

Prix du concurrent :

Les frais d'expédition encourus par le concurrent et votre message a  nous :


20043523
Splined Carrier Adapter with Snap Ring Circlip small
It is possible to retrofit the new splines sprocket system to every Rohloff SPEEDHUB 500/14 transmission. One must simply remove the old, worn sprocket using a chainwhip and our special sprocket remover tool.

Features

  • All Rohloff Splined Sprockets are reversible and constructed to offer a 3mm wider chainline (than the original threaded sprockets) (position of largest sprocket on modern triple cranksets)
  • The belt-line with Carrier of a Carbon Drive transmission remains 55mm (+/-1mm) as before
  • The extended range of sprocket sizes now available, offers a greater choice of primary transmission ratios and thus gear-inches

Material

  • Stainless steel

Weight

  • 38g

Scope of delivery

  • 1 Rohloff Splined Carrier Adapter with Snap Ring Circlip small

Recommendation

Experience shows that regular commuter/leisure cyclists will be best suited using a transmission factor of 2.5 -2.8 Offroad cyclists using 29er/650B/Fatbikes tend to opt for a lighter gear ratio. Solo cyclists weighing less than 100kg may do so. This lighter ratio must not fall below 1.9 however!

The higher the chainring/sprocket ratio, the lower the input torque to the gear-unit. It is imperative therefore that the chainring/sprocket factor does not drop below 1.9 (e.g. 34/17=2.0). The smallest permissible sprocket ratios for a rider weighing less than 100kg are: 40:21, 36:19, 34:18, 32:17, 30:16, 28:15, 26:14 und 26:13 = Factor ~ 1,9.

These are the equivalent to a 22:40 combination on a conventional drivetrain. There is no limit whatsoever for higher ratios which means that you can mount bigger chainrings than shown on the table for extreme downhill racing.

If the SPEEDHUB is mounted on a tandem bicycle or if the rider weighs over 100kg, a chainring/sprocket factor of 2.5 (e.g. 42/17=2.5) must be upheld. This equates to sprocket ratios of: 34:13, 35:14, 38:15, 40:16, 42:17, 45:18, 48:19, 52:21.

ATTENTION
Chain-cases such as Hebie must be checked individually for compatibility. The chain-case must run collision free without touching either hub shell nor the splined carrier!
8540S
4250307407422
Splined Carrier Adapter with Snap Ring Circlip small
It is possible to retrofit the new splines sprocket system to every Rohloff SPEEDHUB 500/14 transmission. One must simply remove the old, worn sprocket using a chainwhip and our special sprocket remover tool.

Features

  • All Rohloff Splined Sprockets are reversible and constructed to offer a 3mm wider chainline (than the original threaded sprockets) (position of largest sprocket on modern triple cranksets)
  • The belt-line with Carrier of a Carbon Drive transmission remains 55mm (+/-1mm) as before
  • The extended range of sprocket sizes now available, offers a greater choice of primary transmission ratios and thus gear-inches

Material

  • Stainless steel

Weight

  • 38g

Scope of delivery

  • 1 Rohloff Splined Carrier Adapter with Snap Ring Circlip small

Recommendation

Experience shows that regular commuter/leisure cyclists will be best suited using a transmission factor of 2.5 -2.8 Offroad cyclists using 29er/650B/Fatbikes tend to opt for a lighter gear ratio. Solo cyclists weighing less than 100kg may do so. This lighter ratio must not fall below 1.9 however!

The higher the chainring/sprocket ratio, the lower the input torque to the gear-unit. It is imperative therefore that the chainring/sprocket factor does not drop below 1.9 (e.g. 34/17=2.0). The smallest permissible sprocket ratios for a rider weighing less than 100kg are: 40:21, 36:19, 34:18, 32:17, 30:16, 28:15, 26:14 und 26:13 = Factor ~ 1,9.

These are the equivalent to a 22:40 combination on a conventional drivetrain. There is no limit whatsoever for higher ratios which means that you can mount bigger chainrings than shown on the table for extreme downhill racing.

If the SPEEDHUB is mounted on a tandem bicycle or if the rider weighs over 100kg, a chainring/sprocket factor of 2.5 (e.g. 42/17=2.5) must be upheld. This equates to sprocket ratios of: 34:13, 35:14, 38:15, 40:16, 42:17, 45:18, 48:19, 52:21.

ATTENTION
Chain-cases such as Hebie must be checked individually for compatibility. The chain-case must run collision free without touching either hub shell nor the splined carrier!
8540S
4250307407422
Évaluations
    5 Étoiles _ (0)
    4 Étoiles _ (0)
    3 Étoiles _ (0)
    2 Étoiles _ (0)
    1 Étoiles _ (0)
Pour soumettre une note, veuillez vous connecter
Dernier visionnement