more products in this category
Show more products in this category
Cube AMS 110 Race 26 Frame black anodizedThe Cube AMS 110 Race 26 frame is a versatile tourer with the potential for all-mountain use.Triple butted High Performance 7005 Aluminium frame features PressFit bottom bracket for a wider junction to the seat and down tubes - guarantees optimum flow of forces and high lateral stiffness. Size Tuned Kinematic four bar linkage with 110mm fully active suspension travel, identical performance for all frame sizes and Efficient Ride Control for tougher rides - minimal bobbing and brake influence
- Material: Aluminium HPA 7005 Advanced Hydroform, Triple Butted, Efficient Ride Control FSP 4-Link
- Seat post: 31.6mm
- Seat clamp: 34.9mm
- Front deraileur: 34.9mm / cable routing from below
- Headtube diameter: 1 1/8" (ZS 44mm) semi-integrated
- Bottom bracket housing: Pressfit 92mm
- Disc brake mount rear: Postmount
- Wheel size: 26"
- Rear Shock installation length: 165x38mm
- Bushings: 22x8mm / 40x8mm
- Recommended Fork Travel: 100 - 120mm
- Dropout: Standard quick release 135mm
- black anodized
- 2600g (22")
Scope of delivery
- Cube AMS 110 Race 26 Frame black anodized
TechnologiesHigh Performance Aluminum
For our high end bikes we use High Performance 7005 Aluminium alloy which has a very low density combined with high strength due to the alloy elements and the hardening heat treatment. By triple butting or even quadruple butting to give different wall thicknesses in one tube, aluminium tubes are reinforced where required and made lighter where possible. In this way, we succeed in getting material where its needed most. In addition we use special tube shapes, manufactured with hydroforming technology to better cope with directional forces. The low density and high strength as well as the butting and the hydroforming technology enable us to make high performance frames with an ultimate level of stiffness.
Integrated Cable Routing
Internally routed cables offer many advantages. Cables are protected from dirt for longer life, weight is saved thanks to the absence of external housing and the bike has a clean, sleek appearance.
Integrated Post Mount
The post mount rear brake system is found on all carbon fiber frames and top aluminum full suspension models. Two bolts and the IS adpater arent needed anymore, and fewer parts means less weight. In this case we save 30 grams. This may not sound a lot. But there's potential to save weight in every detail.
Press Fit BB
With Press Fit bearings, the bottom bracket bearings are pressed directly into the frame and not screwed in as usual. This gives a wider bottom bracket shell and allows us to build a wider down tube and more broadly-spaced chainstays. Every millimetre of additional width gives a significant improvement in lateral stiffness.
This article has not yet been reviewed.